Preparing to attach the hand sewn cover to the canine crate:
1.) Unfold the cover and place in an open area.
Note: Allow the fabric to reach room temperature to assist
with the installation onto your Rover Company Pet
2.) Place one #250 clip into each of the sewn tabs of the Rover
Company Sunbreeze Capped Cover.
3.) On your existing Rover Dog Enclosure, make certain each of the
upper #200 panel hinge clips are roughly 4” below the top of
the Panel. This will assist with keeping the Cover from
slipping up and off the dog enclosure.
4.) Place the cover inside the canine enclosure and secure one
corner of the cover to the outside of the dog enclosure using
the #250 clip installed BELOW the #200 panel hinge clip.
5.) Continue working around the breeze cover, securing each #250
clip as done before, until all the capped cover is secured to the
puppy enclosure with #250 clips.
6.) Finally, pull each corner of the Sunbreeze Cover down until it
is tight across the doggy enclosure.
Congratulations, you are now ready to use your Rover Company Sunbreeze Capped Cover with your Rover Company Animal Enclosure!
USA Made Indoor Plastic Pet Pens :
Company Website : http://www.roverpet.com
X Pen Cover : http://www.roverpet.com/dogs_cats/accessories-en/covers/capped-sunbreeze-covers-en/
Dog Cage Floors : http://www.roverpet.com/dogs_cats/accessories-en/floors-en/
Plastic Exercise Pen: http://www.roverpet.com/dogs_cats/rover-dog-enclosure-4-wide-x-6-long-x-36-high.html